Appearance
Agent Configuration
Use Ordyn Agent Configuration to enroll or repair a Windows device and change local Agent settings. Open Settings from the Ordyn tray icon using a Windows administrator account. Configuration is available even when the Agent is stopped or offline.
Job activity
The Windows tray shows the name of an active job. The activity indicator clears when the job finishes and refreshes after the Agent reconnects. Use the job run in Ordyn to check task results and failures. Linux Agents do not display a tray indicator.
Remote access
Remote Access is enabled by default; unattended access is disabled. Disable Remote Access to refuse new sessions. Enable unattended access only when operators should be able to connect without someone approving at the device.
See Windows Remote Access for consent and session behavior.
Logging
Use Logging to inspect or export operational and audit logs. The normal level is Info; select a more detailed level temporarily when troubleshooting. Standard Windows installations use the Ordyn Agent channels in Event Viewer.
Managed settings
An enforced Ordyn Agent Settings profile takes precedence over local choices. Change the profile to change a managed setting. When management is removed, local choices apply after the updated policy reaches the Agent. Offline devices retain their last applied policy.
Enrollment, reset and repair
Initial enrollment
On Enrollment, enter the Edge host, enrollment token, and endpoint name, then select Enroll device. Follow Enrollment for installation requirements and approval.
Reset enrollment
Use Reset enrollment when the device should receive a new identity, then enroll it again. Reset clears the existing enrollment and unfinished work while preserving local settings and logs.
The old endpoint's history and assignments remain in Ordyn and do not transfer to the new identity. Use repair when you need to preserve them.
Repair the same endpoint
Repair restores an approved endpoint's credentials while preserving its identity, history, inventory, and assignments.
- On the endpoint in Ordyn, select Actions → Create recovery token and copy the token. It expires after one hour and authorizes one repair.
- In Agent Configuration, open Enrollment → Re-register and enter the Edge host, endpoint ID, and recovery token.
- Select Re-register, then verify that the endpoint reconnects.
Issuing the token does not disconnect the endpoint; repair briefly stops its Agent service. If the exchange is interrupted, retry with the same token. Ordinary enrollment tokens cannot repair an existing identity.
Prepare for reinstall is a separate action that immediately revokes credentials and restages the endpoint. Use it for a planned reinstall rather than credential repair.
Linux logging
Linux Agents support the log-level setting. Follow live operational logs with:
bash
sudo journalctl -t ordyn-agent-operational -fThese logs include Update Ordyn API progress while Ordyn itself is unavailable.